18
Main Mode: Thumbnail Screen
Each press of this button turns the shot mark indicator on
and off.
◆
NOTE:
• A shot mark is added to a clip even if the button is pressed in
the record/playback screen.
• When attaching or deleting shot marks for clips that span
multiple P2 cards, be sure to load all the P2 cards that the clip
is recorded on.
• Shot marks cannot be added or deleted during loop recording.
Use the steps below to copy clips to P2 cards or storage
devices connected via USB.
◆
NOTE:
• Take care not to turn off the power or remove a card during copying.
Otherwise the copied clip may become bad.
• If the copied clip is bad, delete it and make a new copy.
• Reconnect incomplete clips before copying them.
1
Open the thumbnail screen.
2
Select a clip to copy.
3
Press the MENU button.
4
Use the cursor buttons to choose the OPERATION -
COPY menu setting, select destination from the list
that appears and press the SET button.
• When multiple clips are selected, press the SET button to
view how many clips are selected.
• When clips are copied to a storage device
(
➝
“Connecting an External Device via the USB HOST
Connector” page 27), select the destination of the copied
data as required.
• When COPY is assigned to a USER button, you can copy
the thumbnail by pressing the USER button instead of
making a menu selection.
5
Select YES in the confirmation message that
appears and press the SET button.
This starts copying.
◆
NOTE:
• To interrupt copying, press the SET or the CANCEL button to
cancel the operation. The incomplete copy at the destination is
deleted.
• “OVERWRITE” appears when an attempt is made to place a
copy (having the same GLOBAL CLIP ID) at a destination
already containing an identical item. Select YES to overwrite or
NO to cancel copying and then press the SET button.
6
Press SET button when the completion message
appears.
◆
NOTE:
• No copying is performed when any of the following error
messages appear.
- “LACK OF CAPACITY”
Copy failed because there is not enough space at the copy
destination.
- “UNKNOWN CONTENTS FORMAT!”
Copy failed because the selected clip was bad.
- “NO COPY TO SAME CARD!”
Copy failed because an attempt was made to place the copy
on the same disk.
- “TOO MANY CLIPS!”
Copy failed because too many clips were selected.
• Copying performed in the lower half of text memo display when
the text memo is selected copies the section from the selected
text memo to the next text memo. When there is no text memo
beyond the selected text memo, the section from the selected
text memo to the end of the clip is copied.
Use the following procedure to delete a clip from a P2 card.
1
Open the thumbnail screen.
Copying Clips
2,4,5,6
2,4,5
3
Deleting Clips
2,4,5
3
