Panametrics DigitalFlow XMT868i, Programming Manual

Page: 131 / 164

DigitalFlow™ XMT868i Programming Manual 57
Appendix C. Programming the XMT868i Using PanaView™
Option Card Alarm Relays
Complete the following steps to set up the alarm relays of an option card installed in Slot 1 (refer to Figure 57 on
page 75):
1. Double-click on the desired Output (A, B, C or D).
Note: The set up of Alarm A is used here as an example. Identical procedures would be used to set up the
additional alarms.
2. Double-click on Off to disable Output A and return to step 1, or on High, Low or Fault to select the desired alarm
type.
3. Double-click on No for standard alarm operation, or on Yes for Failsafe operation. (See Chapter 1, Installation , of
the Startup Guide for failsafe wiring instructions.)
For a 1-Channel meter, proceed to step 5.
4. Double-click on the desired Channel option. See Table 45 for a description of the channel options available.
Note: If FAULT was selected as the alarm type, the next two prompts do not appear. You have completed entering
data in this option.
5. Double-click on the desired Measurement Name . (Table 44 on page 53 provides a description of the available
parameters.)
Note: The measurement units that appear in these prompts are those selected in the Global-System menu earlier
in this section.
6. Enter a value for the Trigger Point of the alarm and click on [Next Item].
After responding to the above prompt, the meter returns to step 1. Click [Exit Page] to proceed to another menu or
option.
Table 45: Channel Options
Option Description
Channel 1 Channel 1
Channel 2 Channel 2
Add Channels CH1+CH2
Subtract Channels CH1-CH2
Average Channels (CH1+CH2)/2