oventrop Regtronic RH HT, Installation And Operating Instructions For The Specialised Installer, Page: 48 / 56

48
Installation
Commissioning
Settings
Data comm
unication
Tr
oubleshooting
en
In- / Outputs / Outputs
Adjustment
channel
Description Adjustment range / selection Factory setting
R1 … R5 Relay output selection - -
Signal Control type Adapter, 0-10 V, PWM, Standard Standard
Output PWM output selection A, B A
Profile PWM characteristic curve Solar, Heating Solar
Min speed Minimum speed (20) 30 … 100 % 30 %
R2,R3 1 (1) A (100 ... 240) V~
R1,R4 4 (2) A (100 ... 240) V~
4 (1) A 240 V~
4 (1) A 24V R5
S-Bus
S-Bus GND
S1 S2 S3 S4 S5 S6 S7 S8 R4 R5
IP20
R5
N
100 ... 240 V~
50-60 Hz
T4A
R3 R2 R1
L' L
GND
Temp. Sensor
0-10V/PWM
A B
RPD
N
Isolate mains before removing cover!
Vor Öffnen Gerät spannungslos schalten!
Use ground common terminal block
Masse-Sammelklemme benutzen
Use neutral conductor common terminal block
Neutralleiter-Sammelklemme benutzen!
Use PE Common terminal block
Schutzleiter-Sammelklemme benutzen
VFD
CS10 V40/S9
B GN
D
24
V
Note:
For pumps with a nominal current > 1A, see page 7.
Characteristic curve profile Solar
Input
Solar
Output
100% 0% PWM
0-10 V
100%
Characteristic curve profile Heating
100% 0% PWM
0-10 V
100%
Input
Heating
Output
Note:
When the minimum pump speed value adjusted in the Outputs menu
differs from the minimum pump speed adjusted in an optional function
that uses the same output, only the higher value will be come into effect.