oventrop Regtronic RH HT, Installation And Operating Instructions For The Specialised Installer, Page: 44 / 56

44
Installation
Commissioning
Settings
Data comm
unication
Tr
oubleshooting
en
When Linear is adjusted in the Logging type adjustment channel, data logging will
stop if the capacity limit is reached. The message Card full will be displayed.
If Cyclic is adjusted, the oldest data logged onto the SD card will be overwritten
as soon as the capacity limit is reached.
Note:
Because of the increasing size of the data packets, the remaining logging
time does not decrease linearly. The data packet size can increase, e. g.
with the increasing operating hours value.
Storing controller adjustments
Î
To store the controller adjustments on an SD card, select the menu item Save
adjustments.
While the adjustments are being stored, first Please wait, then Done! will be
indicated on the display. The controller adjustments are stored as a .SET file on
the SD card.
Loading controller adjustments
Î To load controller adjustments from an SD card, select the menu item Load
adjustments.
The File selection window is indicated.
Î Select the desired .SET file.
While the adjustments are being loaded, first Please wait, then Done! will be
indicated on the display.
Note:
To safely remove the SD card, always select the menu item Remove
card … before removing the card.
SD card
Adjustment channel Description Adjustment range / selection Factory setting
Remove card... Safely remove card - -
Save adjustments Save adjustments - -
Load adjustments Load adjustments - -
Logging int... Logging interval 00:01 … 20:00 (mm:ss) 01:00
Logging type Logging type Cyclic, Linear Cyclic
10 SD card
The controller is equipped with an SD card slot for SD memory cards.
With an SD card, the following functions can be carried out:
• Logging measurement and balance values. After the transfer to a computer, the
values can be opened and visualised, e. g. in a spreadsheet.
• Store adjustments and parameterisations on the SD card and, if necessary, re-
trieve them from there.
• Running firmware updates on the controller.
Running firmware updates
The current software can be downloaded from www.oventrop.de. When an SD
card with a firmware update is inserted, the enquiry Update? is indicated on the
display. The setting can be changed between Yes and No by pressing buttons
❷
and
❹
.
Î To run the update, select Yes and confirm by pressing button
➄
.
The update is run automatically. The indication Please wait and a progress bar
appear on the display. When the update has been completed, the controller will
automatically reboot and run a short initialisation phase.
Î
To skip the update, select No.
The controller starts normal operation.
Note:
The controller will only recognise a firmware update file if it is stored
in a folder named “OVENTROP/RHB” on the first level of the SD card.
Î Create a folder named “OVENTROP/RHB” on the SD card and ex-
tract the downloaded ZIP file into this folder.
Starting the logging
Î Insert the SD card into the slot
Î Adjust the desired logging type and interval
Logging will start immediately.
Completing the logging process
Î
Select the menu item Remove card
Î After Remove card is displayed, remove the card from the slot.