oventrop Regtronic RH HT, Installation And Operating Instructions For The Specialised Installer, Page: 18 / 56

18
Installation
Commissioning
Settings
Data comm
unication
Tr
oubleshooting
en
5.6 Meas. / Balance values
In the Status / Meas. / Balance menu, all current measurement values as well as
a range of balance values are displayed. Some of the menu items can be selected
in order to enter a sub-menu.
Each sensor and relay is indicated with the component or function it has been
allocated to. The symbol
▶
at the edge of the display next to a sensor allocated to
a function, means that this sensor has several functions. Use buttons
❷
and
❹
to
scroll to these functions. The sensors and relays of the controller and all modules
connected are listed in numerical order.
When a line with a measurement value is selected, another sub-menu will open.
If, for example, S1 is selected, a sub-menu indicating the minimum and maximum
values will open.
5.7 Messages
In the Status / Messages menu, error and warning messages are indicated.
During normal operation, the message Everything OK is indicated.
A line break or short circuit in a sensor line is indicated as !Sensor fault. A pre-
cise error code can be found in the Status / Meas.- / Balance values menu.
6 Heating
In this menu, all adjustments for the heating part of the arrangement or for the
heating circuits respectively can be made.
Shared relays for demands, loading pumps or valves can be activated, heating circuits
can be configured and optional functions can be selected and adjusted.
In this menu, the screed drying function can be activated and adjusted.
6.1 Shared relays
In this menu, adjustments for heat generators, loading pumps and valves which
are shared by several heating circuits and their optional functions can be made.
Further options such as boiler protection, start-up and overrun are also available.
Shared relays will be available for selection under Virtual in the heating circuits
and in the relay allocation channels of the corresponding optional functions of the
Heating menu. This way, several heating circuits and optional functions (heating)
can demand the same heat source, use the same loading pump or switch a shared
relay (e. g. a valve).
Note:
Activate and adjust the shared relays first. They will then be available in
the heating circuits and optional functions.