![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-20msp/jlg-20msp_service-and-maintenance-manual_1655764055.webp)
SECTION 3 - BASE COMPONENTS
3-14
31215825
Spindle Sub-Assembly
Figure 3-14. Spindle Sub-Assembly
1.
Place the spindle (G1) on the bench with the carrier por
-
tion facing up.
NOTE:
Do not damage or scratch the seal surface of the spindle
(G1) during assembly.
2.
Using the appropriate pressing tool (T-182377), press on
Main Bearing (G14) until it is fully seated.
3.
Use the Output Planet Pin (G10) as a pressing tool to
install the Planet Bushing (G26) into the bore of each
Planet Gear (G9). The shaft will help guide the bushing
into the bore as well as prevent damage from the press.
4.
Place Tanged Thrust Washer (G32) into each planet “win
-
dow” of the Spindle (G1). Make sure the tang sits in the
cast groove on the inside of the window.
5.
Place a Thrust Washer (G25) onto the Output Planet
Gear (G9). Line up the bores as best as you can. Use
grease to hold the Thrust Washer in place.
6.
Slide the Output Planet Gear (G9) into the window with
the Tanged Thrust Washer (G32) until the bores line up.
7.
Insert Output Planet Shaft (G10) into the Planet Shaft
hole of the Spindle (1) and through the bores of the
Thrust Washers (G25) & (G32) and the Planet Gear (G9).
8.
Before pressing the Output Planet Shaft (G10) into the
Spindle (G1), make sure the Output Planet Gear (G9)
spins freely.
9.
Press the Output Planet Shaft (G10) into the Spindle (G1)
until it bottoms out. Make sure the Output Planet Gear
(G9) spins freely after the Planet Shaft is pressed in.
10.
Repeat Steps 5-11 for the other two Output Planet Gears
(G9).
11.
Turn the Spindle (G1) over so that the carrier end is
down.
12.
Install Input Ball Bearing (G15) into the Spindle (G1)
bore.
13.
Using a flat plate or rod, press the Motor Shaft Seal (G17)
into the center bore so that it is flush with the face of the
Spindle (G1).
Go
to
Discount-Equipment.com
to
order
your
parts