![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-20msp/jlg-20msp_service-and-maintenance-manual_1655764068.webp)
SECTION 4 - CONTROL COMPONENTS
31215825
4-3
4.3 CONTROL COMPONENTS - INSTALLATION
BEFORE REMOVING ANY COMPONENT FROM THE ELECTRI
-
CAL SYSTEM, DISCONNECT THE POSITIVE TERMINAL FROM
THE LEFT SIDE BATTERY.
Ground Control Module
The Ground Control Module is located under the center cover
at the rear of the machine and is mounted on the mast sup
-
port column. All electrical components on the machine oper
-
ate directly or indirectly through the Ground Control Module.
The module is currently programmed at the factory with the
machines operating profile. If replacing a Ground Control
Module the new module may require some programming to
enable any optional equipment. See Section 4.6, Ground Con
Traction Control Module
The Traction Control Module is mounted below the Ground
Control Module on the mast support column.
The traction module controls the voltage to the drive motors
as regulated by the ground control module, from signals
received via the joystick controller located on the platform
control module.
There are no internal parts serviced on this module.
Note:
See Figure 4-9. for wiring connection instructions.
1
2
2
Note:
See Figure 4-9. for wiring connection instructions.
1
2
2
1.
Ground Control Module
2.
Attach Screws/Washers
Figure 4-2. Ground Control Module Installation
1.
Traction Control Module
2.
Attach Screws/Washers
Figure 4-3. Traction Control Module Installation
Go
Discount-Equipment.com
to
order
your
parts