![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-20msp/jlg-20msp_service-and-maintenance-manual_1655764156.webp)
SECTION 6 - TROUBLESHOOTING
6-28
31215825
Code 23 - Horn - Disconnected
Check For These Obvious Conditions First:
• Is machine equipped with a horn unit.
Code 24 - Auxiliary #1 Circuit - Short Circuit
Check For These Obvious Conditions First:
• Damaged wiring in the Auxiliary #1 Component wiring harness or a damaged Component.
Table 6-26. Code 23 - Horn - Disconnected
STEP
ACTION
SPEC
YES
NO
1.
Is machine equipped with a horn unit.
—
Go to Step 3
Got to Step 2
2.
At the Ground Control Module enter the programming mode, check
if the horn open circuit detection is enabled.
—
Disable It
Replace Ground
Control Module
3.
Check voltage at the P1 connector on the Ground Control Module
between pin-14 and pin-7. Is reading within specification?
2 - 4 V DC
Replace Ground
Control Module
Go to Step 4
4.
Remove the wire terminals at the horn, check continuity of each of
the wires from pins-14 and 7 on the P1 connector to the horn end.
—
Replace the
Horn
Repair or
Replace Wiring
Table 6-27. Code 24 - Auxiliary #1 Circuit - Short Circuit
STEP
ACTION
SPEC
YES
NO
1.
At the Ground Control Module, P1 connector, check the voltage
across pins-9 and 2 to the horn. Is reading within specification?
0 - 2V DC
Go to Step 2
Replace Ground
Control Module
2.
Remove the wire terminals at the horn, check continuity of each of
the wires from pins-9 and 2 on the P1 connector to the component
end.
—
Replace the
Component
Repair or
Replace Wiring
Go to
Discount-Equipment.com
to
order your
parts