![background image](http://html1.mh-extra.com/html/oshkosh-corporation/jlg-20msp/jlg-20msp_service-and-maintenance-manual_1655764090.webp)
SECTION 4 - CONTROL COMPONENTS
31215825
4-25
Brush Housing Final Assembly Tips
It is easier to install the brush housing assembly by sliding the
rotor assembly completely out of the other end of the motor
housing, then attach the brush housing first. After the brush
housing is installed look into the motor housing from the
opposite end to check that the positive (+) post wires and
static winding wires are positioned, not to block the holes for
the motor mounting bolts, inside the motor housing.
After final assembly of the brush housing check that all brush
terminal screws are tight and the brush springs are positioned
properly before mounting the motor to the pump/motor end
head.
Figure 4-45. Brush Final Positioning
ONCE THE ROTOR ASSEMBLY IS IN PLACE, REMEMBER
TO PUSH EACH BRUSH DOWN UNTIL THE BRUSH FACE
IS IN CONTACT WITH THE COMMUTATOR ON THE
ROTOR SHAFT AND THE BRUSH SPRING IS PUSHING
DOWN ON TOP OF THE BRUSH.
Go
to
Discount-Equipment.com
to
order
your
parts