Operating instructions for Pool control-40.net filter control unit
Page: 19 (34)
ECO mode
Press the button.
Use the
and
buttons to scroll through the menu until the
display shows "ECO mode".
Press the button again to select ECO mode.
Timer
Press the
button to program the timer settings (see procedure
described under Timer programming)
Temperature
reduction
Use the
and
buttons to scroll through the ECO mode until the
display shown here appears.
Press the
button to set the temperature reduction using the
and buttons. Then press the button to save the setting.
Adjustment range 0 to 15°, factory setting 0°
Heating
Press the button.
Use the
and
buttons to scroll through the menu until the
display shows "heating".
Press the button to select the heating settings.
Operating
mode
Press the button.
The display shows the current heating operating mode (automatic
mode or off). You can use the
and
buttons to change the
selection. Press the button to save the setting.
Priority
Use the and buttons to scroll through the heating settings until
the display shown here appears.
Press the button to enable or disable the priority using the and
buttons. Press the
button to save the setting. With priority off
(disabled), the heating is only actuated during filtration operating
times.
Factory setting: priority off
Minimum
switching
interval
Use the and buttons to scroll through the heating settings until
the display shown here appears.
Press the
button to set the minimum switching interval
(hysteresis) using the and buttons. Press the button to save
the setting. The minimum switching interval is set in seconds.
Adjustment range 10 to 1800s, factory setting 120s
Over-run time
Use the and buttons to scroll through the heating settings until
the display shown here appears.
Press the button to set the over-run time (subseq. run) using the
and buttons. Press the button to save the setting. When an
over-run time is active, the timer switches the heating off at the end
of the filtration operating time, but the filter pump keeps running for
the period set by the over-run time.
Adjustment range 0 to 1800s, factory setting 0s
Temperature
limit
Use the and buttons to scroll through the heating settings until
the display shown here appears.
Press the
button to set the temperature limit using the and
buttons. Press the
button to save the setting. The temperature
limit is the maximum water temperature that can be selected.
Adjustment range 30 to 50°C, factory setting 40°C
