Oracle Fabric Interconnect F2-12, Installation Manual

Page: 70 / 118

Connect the QSFP Cables
The shell should not be bent and should be parallel to the inner boards. If the connector is bent
or damaged, use a different cable.
3. Ensure that the retraction strap is folded back against the cable.
4. Orient the cable connector to the QSFP receptacle squarely and vertically.
For the Oracle F2 10 Gb and 40 Gb Ethernet module, ensure that the L groove is to the right.
5.
Slowly move the connector in.
As you slide the connector in, the shell should be in the center of the QSFP receptacle.
■ If the connector stops or binds after about 1/4 in. (5 mm) travel, back out and
repeat from Step 4 .
■
If the connector stops or binds with about 1/8 in. (2 mm) still to go, back out
and repeat Step 5 .
6. Connect the cable.
7. Lay the cable into a slot on the cable management comb.
8. Continue to push the connector in until you feel it seat.
70 Oracle Fabric Interconnect F2-12 Installation Guide • November 2016