Operation
Version 1.0.1 dated 2017-11-16
Page 49
Translation of the original instructions
TX6222
GB
T
X
6222
_GB
_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
The infeed is performed with the handwheel of the top slide. The depth of cut is advanced with
the handwheel of the cross slide.
Img. 4-8:
Cone setting with stop measure
3. By measuring an existing cone with gauge and stand.
The stand is put on the top slide. The gauge is aligned horizontally and 90° to the top slide. The
top slide is approximately adjusted to the cone angle and the test prod brought in contact with
the cone surface (fix the bedslide). Now the top slide is twisted in a way that the gauge does not
indicate any travel of the pointer over the whole length of the cone (offset over the handwheel
of the top slide).
Then you may start reaming the lathe as described under point 2. The workpiece might be a
flange for lathe chucks or a face plate.
Img. 4-9:
Cone setting with stop measure
4. By offsetting the tailstock as the cone length is larger than the adjustable stroke of the top
slide.
The workpiece is clamped between two points, therefore center holes are required on the face.
They are to be drilled before removing the lathe chuck. The slaving of the workpiece is per-
formed by a pulling pin and a lathe carrier.
Gauge
Stop measure 100 mm
Dog
Measuring direction
Advance of depth of cut
Feed di
rection
Gauge
Advance of depth of cut
Measurin
g and
Feed dire
ction
