Operation
Version 1.0.1 dated 2017-11-16
Page 34
Translation of the original instructions
TX6222
GB
T
X
6222
_GB
_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4.2
Safety
Commission the lathe only under the following conditions:
The lathe is in proper working order.
The lathe is used as prescribed.
Follow the operating instructions.
All safety devices are installed and activated.
Eliminate or have all malfunctions rectified promptly. Stop the lathe immediately in the event of
any abnormality in operation and make sure it cannot be started-up accidentally or without
authorisation.
Notify the person responsible immediately of any modification.
"Safety during operation“ on page 17
4.3
Switching on the machine
Switch on the main switch.
Check that the emergency-stop button is not pressed or is unlocked. Turn the emergency-
stop button to the right in order to release the push button.
Set all of the actuators in the neutral position and close the lathe chuck protection.
The control lamp ( 3 ) for operation must be on.
4.4
Switching off the machine
CAUTION!
Only press the emergency-stop button in a genuine emergency. You should not use the
emergency stop button to stop the machine during normal operation.
Switch off the master switch.
If the lathe has been shut off for a longer period of time, switch it off using the main switch
and secure it against being unintentionally switched back on.
4.5
Resetting an emergency stop condition
Set the rotational direction control lever to the neutral position.
Unlock the emergency stop switch again.
4.6
Power failure, Restoring readiness for operation
Set the rotational direction control lever to the neutral position.
4.7
Foot brake
Activating the foot brake deactivates the drive and brakes the spindle.
Set the lever of rotational direction back to the neutral position.
