Operation
Version 1.0.1 dated 2017-11-16
Page 42
Translation of the original instructions
TX6222
GB
T
X
6222
_GB
_4.
fm
OPTIMUM
M A S C H I N E N - G E R M A N Y
®
4.13
Mounting workpiece holder
DANGER!
Please observe the maximum permissible rotational speed of chucks and face plates
with individually tensionable jaws.
4.13.1 Centering point in lathe spindle
Clean the taper bore of the lathe spindle holding fixture.
Clean the morse taper and the taper of the centring point.
Push the fixed MT5 center with reducing cone MT5 obtained in your delivery into the inter-
nal taper of the spindle holding fixture.
4.14
Mounting of rests
4.14.1 Follow rest and steady rest
Use steady rest or follow rest to support longer parts and prevent the workpiece from flapping
around and flying away.
CAUTION!
When mounting a rest, the rest is due his function near the top slide, which results in
additional crushing and shearing points between the guide of rest and the workpiece.
Increased attention is therefore absolutely necessary when working with an rest.
Steady rest
P
7
P
168
