One Stop Systems
ExpressBox 3200 | 2 Hardware Installation
17
2.5
Install Host Interface card
Begin the installation of your Host Interface card by first powering down your computer.
The Host Interface card is a “half-height,” x8-capable PCIe card mounted to a “full-height” bracket, see picture below.
For low profile case applications, you may need to change the mounting bracket to the low profile bracket that shipped with your system, see
picture below. This is done by removing the screws that hold the card to the bracket. Be sure you are using proper ESD procedures when
completing this action.
WARNING
You must only install the Host Interface card
into a
PCI EXPRESS SLOT
.
Only use Interface card WITH bracket.
This will ensure that your PCIe host card can only be inserted into a PCIe slot.
Once the host computer is turned OFF and the power cord is disconnected from the AC outlet, remove the cover. Check the red Dipswitch
(SW4) on the Interface card, make sure it is set to “OFF= HOST”.
Insert the Host Interface card into a vacant x8 (or x16) PCIe slot by gently pushing the card until it is firmly seated. Then secure the card into
the slot with a mounting screw.
Summary of Contents for EB3200
Page 1: ...ExpressBox 3200 PCIe to PCIe Expansion User Manual SKU EB3200 www onestopsystems com...
Page 13: ...One Stop Systems ExpressBox 3200 1 Introduction ExpressBox 3200 13 1 8 Parts Overview...
Page 31: ...One Stop Systems ExpressBox 3200 2 Hardware Installation 31 2 8 2 Clamp Position Orientation...
Page 85: ...Manual P N 09 09959 03 Rev A...
