One Stop Systems
ExpressBox 3200 | 2 Hardware Installation
14
2 Hardware Installation
The following steps will guide you through the installation of your OSS Expansion System.
CAUTION
Hardware installation shall be performed only by qualified service personnel.
Electrostatic Discharge (ESD) Warning
All add-in cards are susceptible to electrostatic discharge. When moving cards, it is best to carry the cards in anti-static
packaging. If you need to set a circuit card down, be sure to place it inside or on top of an anti-static surface. For more
information, see “Protecting Against Electrostatic Discharge” in the Preface.
WARNING
High voltages are present inside the expansion chassis when the unit’s power cord is plugged into an electrical outlet.
Disconnect the power cord from the AC outlet before removing the enclosure cover. Turning the system power off at the
power on/off switch does not remove power to components. High voltage is still present.
CAUTION
Before touching anything inside the enclosure, move to an ESD station and follow proper ESD procedures. Failure to do so
may result in electrostatic discharge, damaging the computer or its components. For more information, see “Protecting
Against Electrostatic Discharge” in the Preface.
2.1
Tools Required for Installation
To complete the installation of the OSS product you will need a Phillips-head screwdriver and ESD wrist strap to prevent electrostatic discharge.
Summary of Contents for EB3200
Page 1: ...ExpressBox 3200 PCIe to PCIe Expansion User Manual SKU EB3200 www onestopsystems com...
Page 13: ...One Stop Systems ExpressBox 3200 1 Introduction ExpressBox 3200 13 1 8 Parts Overview...
Page 31: ...One Stop Systems ExpressBox 3200 2 Hardware Installation 31 2 8 2 Clamp Position Orientation...
Page 85: ...Manual P N 09 09959 03 Rev A...
