![background image](http://html1.mh-extra.com/html/omron/v500-r2-series/v500-r2-series_user-manual_741439032.webp)
30
Section
2
Wi
ri
ng
V500-R2 series
User’s Manual
Section 2
Wiring and Installation
Wiring
Wiring diagram
V500-R2 series
Connection with upper equipment p.98, p.99
• Extension length of the RS-232C line (SD, RD, and SG) should be up to 15 m.
• Wiring should avoid approaching to a high-power heavy electric current wire.
• Turn off the power switch before connecting or disconnecting a connector.
• To assure noise and insulation resistance, be sure to use S8VS-01505 (made by OMRON) as a driving power
supply.
• Do not connect a voltage or AC power supply that has a voltage exceeding the rating voltage (5 V+/-10%).
• Avoid reverse connection of power supply. Do not short circuit a load on OK/NG output signal (open
collector).
Wire color Pin No. Signal name
Function
Signal direction
Reader
Upper equipment
Green
1
SD
Transmission data
White
2
RD
Received data
Gray
3
RS
Transmission request
Blue
4
CS
Transmission allowed
Brown
5
TRIG
External trigger signal
-
6
NC
Not connected
Black
7
S.GND
0 V
External
Red
8
VCC
Power supply
External
Yellow
- (Note)
OK
READ OK output
External
Orange
- (Note)
NG
READ NG output
External
The OK and NG output lines are not connected to the DIN 8-pin connector. To use the OK and NG
outputs, cut the cables.
(Pin alignment)
Connector part (DIN: 8P plug)
Made by Hosiden Corporation
TCP1394-715267 (TypeA)
Summary of Contents for V500-R2 Series
Page 1: ...Z334 E1 01A Cat No Fixed Laser Type Barcode Reader User s Manual V500 R2 Series...
Page 18: ...16 V500 R2 series User s Manual Introduction Contents Introduction MEMO...
Page 36: ...34 Section 2 Installation V500 R2 series User s Manual Section 2 Wiring and Installation MEMO...
Page 143: ......