Omron trajexia CJ1W-MCH72, Operation Manual

Page: 35 / 374

Motion sequence and axes Section 1-8
24
All non allocated axes are set as a virtual axis. The value for the parameter
ATYPE is 0.
Every axis has the general structure as shown in the illustration above .
The motion sequence which will be executed at the beginning of each servo
period will contain the following elements:
1 Transfer any moves from BASIC process buffers to motion buffers (see
section 1-9).
2 Read digital inputs.
3 Load moves. (See note.)
4 Calculate speed profile. (See note.)
5 Calculate axis positions. (See note.)
6 Execute position servo. For axis 0 this also includes the Servo Driver
communications. (See note.)
7 Update outputs.
1-8-1 Profile generator
The profile generator is the algorithm that calculates the demanded position
for each axis. The calculation is made every motion sequence.
The profile is generated according to the motion instructions from the BASIC
programs.
1-8-2 Position loop
The position loop is the algorithm that makes sure that there is a minimal
deviation between the measured position (
MPOS ) and the demand position
( DPOS ) of the same axis.
1-8-3 Axis sequence
• The motion controller applies motion commands to an axis array that is
defined with the BASE command. If the motion command concerns one
axis, it is applied to the first axis in the BASE array. If the motion command
concerns more than one axis, and makes an orthogonal move, the axes
are taken from the array in the order defined by the
BASE command. For
Note Each of these items will be performed for each axis in turn before moving on to the next
item.
Basic Program
.........
.........
MOVE(1000)
.........
.........
Profile generator
Demand Position