Omron SYSMAC C200H-PID0 Series, Operation Manual

Page: 32 / 68

24
Operation Keys
Name Function
Level Key The parameter items are divided into three display groups (Refer
to display levels 0 to 2 in the table below). Press this key to
switch from one group to another. The display levels
automatically cycle in the sequence 0 –> 1 –> 2 –> 0 when the
key is held down for approximately 2 seconds.
Display Key Press this key to select the required parameter from the selected
display level 0 to 2 (Refer to table below).
The parameters cycle automatically when the key is held down.
Loop Key Press this key for approximately two seconds to switch between
Loop 1 and Loop 2.
Up Key Press this key to increment SV.
The SV increment continuously while the key is held down. The
SV display blinks when the value reaches its upper limit.
Down Key Press this key to decrement an SV.
The SV decreases continuously while the key is held down. The
SV display blinks when the value reaches its lower limit.
3-4 Parameter Displays and Settings
3-4-1 Table of Parameters
Display
level
Parameter Display
symbol
Write Read Loop
no.
Bank
no.
Data range Default value Page
0 PV monitor
(see note 3)
---
No Yes Yes No Scaling lower
limit –10% to
scaling upper
limit +10% (Unit: EU) 26
Manual output
volume
(see note 6)
o
Yes Yes Yes No -5 to 105% 0% 26
Set point (see
note 3) --- Yes Yes Yes Yes Scaling lower
limit to scaling
upper limit 0 EU 26
Bank number
bk
See
note 5 Yes Yes No 1 to 8 1 26
Alarm SV 1 (see
notes 3, 4)
al–1
Yes Yes Yes Yes
Alarm mode
1, 4, 5:
0 to 9999 0 EU 27
Alarm SV 2 (see
notes 3, 4)
al–2
Yes Yes Yes Yes
0 to 9999
Other:
–999 to 9999
Input shift value
(see note 3)
in–5
Yes Yes Yes Yes –999 to 9999 0 EU 27
Proportional band
(see note 1)
p
Yes Yes Yes Yes 0.0 to 999.9% FS 10.0% FS 27
Integral (reset)
time (see note 1)
i
Yes Yes Yes Yes 0 to 9999 s 240 s
Derivative (rate)
time (see note 1)
d
Yes Yes Yes Yes 0 to 9999 s 40 s
Parameter Displays and Settings
Section 3-4