Omron SYSMAC C1000H, Operation Manual

Page: 126 / 396

120
TIM 002 when 00000 goes ON and 00500 is necessary to activate TIM 002
(when 00000 is OFF).
00000
00500 00000
TIM 001
TIM 002
00000
00500
5.0 s 3.0 s
Address Instruction Operands
00000 LD 00000
00001 TIM 001
# 0050
00002 LD 00500
00003 AND NOT 00000
00004 TIM 002
# 0030
00005 LD TIM 001
00006 LD TIM 002
00007 KEEP(11) 00500
TIM 001
#0050
TIM 002
#0030
S
R
KEEP(11)
00500
5.0 s
3.0 s
The length of time that a bit is kept ON or OFF can be controlled by combin-
ing TIM with OUT or OUT NO. The following diagram demonstrates how this
is possible. In this example, 00204 would remain ON for 1.5 seconds after
00000 goes ON regardless of the time 00000 stays ON. This is achieved by
using 01000 as a self-maintaining bit activated by 00000 and turning ON
00204 through it. When TIM 001 comes ON (i.e., when the SV of TIM 001
has expired), 00204 will be turned OFF through TIM 001 (i.e., TIM 001 will
turn ON which, as a normally closed condition, creates an OFF execution
condition for OUT 00204).
00000
TIM 001
01000
01000
01000 TIM 001
01000
00204
00000
00204
1.5 s 1.5 s
Address Instruction Operands
00000 LD 01000
00001 AND NOT TIM 001
00002 OR 00000
00003 OUT 01000
00004 LD 01000
00005 TIM 001
# 0015
00006 LD 01000
00007 AND NOT TIM 001
00008 OUT 00204
TIM 001
#0015
1.5 s
Bits can be programmed to turn ON and OFF at regular intervals while a des-
ignated execution condition is ON by using TIM twice. One TIM functions to
turn ON and OFF a specified bit, i.e., the Completion Flag of this TIM turns
the specified bit ON and OFF. The other TIM functions to control the opera-
tion of the first TIM, i.e., when the first TIM’s Completion Flag goes ON, the
Example 4:
One-Shot Bits
Example 5:
Flicker Bits
Timer and Counter Instructions
Section 5-12