Omron NS-CXDC1-V3, User Manual

Page: 40 / 115

18
Uninstalling Section 2-3
2-3 Uninstalling
Operation Procedure
1,2,3... 1. To uninstall the CX-Designer, click the Windows Start Button and select
Settings - Control Panel .
2. Double-click Add/Remove Applications .
3. Select CX-Designer_V
@
.
@
from the list and click the Edit/Delete Button
(“ @ . @ ” represent the version number.) Follow the instructions displayed in
the window messages to uninstall the CX-Designer.
4. When uninstalling the CX-Designer has been finished, a message will be
displayed indicating that the uninstall operation has been completed.
Check the message and then click the
Finish Button.
2-4 Installing USB Drivers for NS-Series PTs.
Install the NS-series USB driver in the personal computer. After installation,
data can be transferred between the personal computer and NS-series PT via
USB.
Note (1) With NS-V1 Series models, make sure that the PT has a lot number that
supports USB transmission. The system program version of the NS-se-
ries PT must also support USB transmission. For details, refer to 3
-3-2
Connecting via USB in the NS series Setup Manual (Cat. No. V083).
(2) If an NS-series USB driver has already been installed for use with the NS-
Designer, the NS-series USB driver must be installed again to use the
CX-Designer.
(3) Do not install the NS-series USB driver for the NS-Designer while the CX-
Designer is being used.
Applicable Operating
Systems Windows 2000, Windows XP, and Windows Vista
Operation Procedure
1,2,3... 1. Start Windows 2000, Windows XP, or Windows Vista.
2. Connect the personal computer to the NS-series PT USB slave connector
using the USB cable. The following Found New Hardware Wizard will be
displayed.