Omron CXONE-ALD-V4 - 10-2010, Operation Manual

Page: 86 / 144

70
Indication and Setting (Block Model 031) Section 6-8
6: Wait Setting Button
This button displays the Wait Width Setting Screen for Segment Program 2.
7: Return Button
This button displays the Tuning Screen for Segment Program 2.
■
Wait Width Setting Screen
1: Wait Width and Wait Time
The wait width and maximum wait time are input for each step. The ten-key
pad is used, just as it was for the Time Width-Output Value Setting Screen.
2: Read Button, 3: Write Button, and 4: Backup Button
The functions of these buttons are the same as those on the Time Width-Out-
put Value Setting Screen.
6-8 Indication and Setting (Block Model 031)
This section describes only the differences between the Indication and Setting
Block and Basic PID Block (Block Model 011). For details on the areas not
covered here, refer to
6-1 Basic PID (Block Model 011) .
6-8-1 Face Plates
The face place for the Indication and Setting Block is almost the same as the
one for the Basic PID Block (Block Model 011), except that the Indication and
Setting Block face plate does not have the MV-related functions and the SP
can be switched between LOCAL and CAS.
1 2 3 4