Omron CXONE-ALD-V4 - 10-2010, Operation Manual

Page: 19 / 144

3
System Requirements Section 1-2
1-2 System Requirements
The following hardware and software is required to install and operate the
Face Plate Auto-Builder for NS.
1-2-1 Computer
■
Computer
IBM PC/AT or compatible
■
CPU
I
ntel CPU (Core, Pentium, or Celeron family)
For Windows Vista: 1 GHz min.
For any other OS: 333 MHz min. required, 1 GHz min. recommended
■
Memory
For Windows Vista: 1 GB min.
For any other OS: 256 MB min. required, 512 MB min. recommended
1-2-2 OS
Windows XP Professional (Service Pack 3) (see note), Windows Vista (Ulti-
mate or Business), or Windows 7 is required.
Note: The 64-bit versions are not supported.
1-3 Application Environment
The Face Plate Auto-Builder for NS uses tag files created with the following
software.
CX-Process Tool
■
Using a Loop Control Board
CX-Process Tool Ver. 3.0 or later
■
Using a Loop Control Unit
CX-Process Tool Ver. 2.0 or later
Projects built with the Face Plate Auto-Builder for NS are used with the follow-
ing hardware and software.
Loop Control Unit,
Loop Control Board,
Loop Control CPU
Unit, or Process-
control CPU Unit
CS1W-LC001 Ver. 2.0 or later
CS1W-LCB01/05 Ver. 1.0 or later
CJ1G-CPU @@ P Ver. 2.0 or later
CS1D-CPU @@ P Ver. 1.0 or later
Note 1. CX-Process Tool Ver. 3.2 or later must be used to output any EM banks
other than bank 0 to the area allocated for the Loop Control Board’s HMI.
2. Backup cannot be performed during operation with versions of the CS1W-
LCB01/05 Loop Control Boards earlier than version 1.5 or CS1W-LC001
Loop Control Units. With other Units/Boards, data can be backed up during
operation from the detail setting screens for the Segment Program 2 face
plate that is built.
NS-Designer
NS-Designer Ver. 2.0 or later