Omron CS1 -, Operation Manual, Page: 142 / 173

8-3 Section Cycle Time
122
Code OFF
execution
time (
µ
s)
Conditions ON
execution
time (
µ
s)
Mnemonic
--- PLS2
99.0 Words for control words
0.9
105.0
:
DM for control words
--- SBBL 14.1 Word – word
→
word 0.9
29.3
:
DM –
:
DM
→ :
DM
--- SCL2
19.6 Word
→
word conversion, words for parameter words
0.9
34.9
:
DM
→
:
DM conversion,
:
DM for parameter words
--- SCL3 20.2 Word
→
word conversion, words for parameter words 0.9
35.1
:
DM
→
:
DM conversion,
:
DM for parameter words
--- ZCP 6.2 Comparing a constant to a word range 0.9
8.0 Comparing a word to a word range
22.1 Comparing
:
DM to a
:
DM range
--- ZCPL
12.1 Comparing words to a word range
0.9
27.7 Comparing
:
DM to a
:
DM range
--- TMHH 6.8 Constant designation 2.3
7.6 Word designation
6.8
:
DM designation
8-3-3 I/O Response Time
The I/O response time is the time it takes after an input signal has been received
(i.e., after an input bit has turned ON) for the Customizable Counter Unit to check
and process the information and to output a control signal (i.e., to output the re-
sult of the processing to an output bit). The I/O response time varies according to
the timing and processing conditions.
The minimum and maximum I/O response times are shown here, using the fol-
lowing program as an example.
Input
Output
The following conditions are taken as examples for calculating the I/O response
times.
Input ON delay: 0.05 ms
Overseeing time: 0.1 ms
Instruction execution time: 0.001 ms
Output ON delay: 0.1 ms
Position of output instruction: Beginning of program
Communications ports:
Not used.