Mounting the C200HW-CORT21-V1
Section 3-2
35
3-1-6 Node Address Switches
The switches at the rear of the Unit are used to set the CANopen Node
Address. Only the first 7 switches are used, the last switch is reserved for
future use and should remain in the OFF position. The following table lists
the DIP switch settings and the corresponding Node Addresses.
NA6
(2
6
)
NA5
(2
5
)
NA4
(2
4
)
NA3
(2
3
)
NA2
(2
2
)
NA1
(2
1
)
NA0
(2
0
)
Node Address
OFF
OFF
OFF
OFF
OFF
OFF
OFF
0 *
OFF
OFF
OFF
OFF
OFF
OFF
ON
1
OFF
OFF
OFF
OFF
OFF
ON
OFF
2
ON
ON
ON
ON
ON
OFF
ON
125
ON
ON
ON
ON
ON
ON
OFF
126
ON
ON
ON
ON
ON
ON
ON
127
* Invalid Node Address. IR n+3.08 and the 7-segment display will indicate this error.
3-2
Mounting the C200HW-CORT21-V1
The C200HW-CORT21-V1 CANopen Slave Unit can be mounted to the CPU
Rack or Expansion I/O Rack of any CS1, C200HX, -HG, or -HE PLC. Refer
to the PLC’s Operation Manuals for details on mounting Units.
Limitations
There are some limitations on mounting the Unit.
•
The current consumption of all Units mounted on one backplane should
not exceed the maximum output of the power supply. The C200HW-
CORT21-V1 consumes up to 250 mA from the 5V supply. Verify the
characteristics of all other Units on their respective Instruction Sheet or
Installation Manual.
•
The C200HW-CORT21-V1 is a Special I/O Unit. It can be mounted in
any slot in the backplane of a CPU Rack or Expansion I/O Rack as long
as its Machine number is not the same as the Machine number of
another Special I/O Unit within the system.
•
The maximum number of Special I/O Units that can be mounted depends
on the PLC CPU type.
•
For details on CS1-series PLC compatibility, see Appendix C.
Summary of Contents for C200HW-CORT21-V1
