42
DM Area Allocations
Section 3-2
Note
1.
Do not specify settings other than those listed in the
Settings
column
above.
2.
When the start mode is set to start automatically, the message “Please
wait compiling...,” which is normally output to the terminal port when a pro-
gram is run, will not be output when the power is turned ON/OFF or when
the START/STOP switch is used.
3.
When there is an error in the DM settings, the ERR indicator will be lit.
Since terminals cannot be connected when this indicator is lit, use a Pro-
gramming Console to confirm the error code, reset the DM settings cor-
rectly, and either turn the power OFF then ON again, or restart the ASCII
Unit.
09
m + 9
00 to
15
Not used
10 to 99
m + 10
to
m + 99
00 to
15
IORD Area and IOWR Area
(set first words at address 6 and 7)
00
Shared
memory
address
DM
address
Bit
Name
Function
Settings (hex)
ASCII Unit’s
default
(hex)
Summary of Contents for C200H-ASC11
Page 1: ...C200H ASC11 ASC21 ASC31 ASCII Units Operation Manual Revised June 2000...
Page 2: ...iv...
Page 4: ...vi...