117
Programming Procedure
Section 7-1
7-1-3
Transferring BASIC Programs Between ASCII Unit and Terminal
Transferring BASIC Programs to the Terminal
Use the following procedure to send BASIC programs from the user memory
(RAM) of the ASCII Unit to the terminal.
Terminal: VT100 Mode (Windows: Hyperterminal)
1,2,3...
1.
Connect the terminals and input “SAVE #1” or “SAVE #3” (for C200H-
ASC31 only) and then press the Enter Key. (See note.)
Example:
SAVE #1, “TERM: 9600, 8, n, 2, CTS_OFF, RTS_OFF, DSR_OFF,
XN_ON”
2.
Enable the text data receiving mode at the terminal. (See note.)
3.
When the terminal indicates that it is waiting to receive data, press the
Ctrl+C Keys. When the ASCII Unit begins to transfer data, the T/R indicator
will flash. (See note.)
4.
Once the ASCII Unit has finished transferring all the data, end the text data
receiving mode at the terminal.
5.
Press the Ctrl+C Keys to display the prompt again.
Note
If a password has been set in the BASIC program with the PWORD com-
mand, use the following procedure.
1,2,3...
1.
Input “SAVE #1” or “SAVE #3” (for C200H-ASC31 only) and press the En-
ter Key. “PASSWORD” will be displayed at the ASCII Unit. Input the pass-
word.
2.
Enable the text data receiving mode at the terminal.
3.
When the terminal is ready to receive data, press the Ctrl+C Keys.
Steps 4 and 5 are the same as for the above procedure.
Terminal: FIT10 Mode
1,2,3...
1.
Set the START/STOP switch to STOP.
2.
Input “SAVE #1” or “SAVE #3” (for C200H-ASC31 only) and press the En-
ter Key at the terminal. The ASCII Unit will be in a transfer wait state. This
is indicated by the flashing BASIC indicator. (See note.)
Example:
SAVE #1, “TERM: 9600, 8, n, 2, CTS_OFF, RTS_OFF, DSR_OFF,
XN_ON”
3.
Enable the text data receiving mode at the terminal.
4.
Set the START/STOP switch to START. When the ASCII Unit begins trans-
ferring data, the T/R indicator will flash.
5.
Once the ASCII Unit has finished transferring all the data, set the START/
STOP switch to STOP, and the prompt will appear again.
6.
End the text data receiving mode at the terminal.
Note
If a password has been set in the BASIC program, “PASSWORD” will be dis-
played at the ASCII Unit. Input the password and press the Enter Key. Once
the ASCII Unit is in a transfer wait state, continue with the same procedure.
Summary of Contents for C200H-ASC11
Page 1: ...C200H ASC11 ASC21 ASC31 ASCII Units Operation Manual Revised June 2000...
Page 2: ...iv...
Page 4: ...vi...