63
Using an RDS Encoder After Omnia.9
You can also use an RDS encoder after Omnia.9, but doing so means losing loudness since Omnia.9’s
composite clipper cannot process the fully encoded signal. In this case, Omnia.9’s MPX 1 Output will
feed the encoder’s MPX Input while the MPX 2 Output will feed the Pilot Input (Sync) of the external
encoder. The output of the encoder will then feed the composite STL or exciter.
In this scenario, the MPX 2 Output control should be set to the MPX Pilot mode.
Summary of Contents for Omnia.9
