Omnia Omnia.9, Installation And Operation Manual

Page: 61 / 127

53
top right portion of the display. Any changes you make to the display settings are saved as you
make them for that particular preset.
For example, you may wish to devote one preset to nothing but the Undo and Processing Meters to
display these parameters in greater detail.
Or, you could devote an entire preset to the oscilloscope and monitor the program input, the output
of Undo, the MPX before the clipper, and the MPX output to see what the various stages within
Omnia.9 are doing to the audio signal.
The combinations are endless and yours to customize to suit your particular needs and preferences.
Undo Meters Menu
The Undo Meters button allows you to display the activity of the entire Undo section. Which
specific Undo meters are displayed within this window is determined by settings in the Undo
Metering portion of the main Undo menu, which is located in Omnia.9’s Input section. A full
explanation of the Undo meters is given in the section dedicated to using Undo.
The Delay control, which is also present in (and coupled to) the Processing Meters,
Oscilloscope, RTA, and FFT Spectrum Analyzer menus, lets you synchronize Omnia.9’s
meters with the audio to which you are listening. For example, if you are listening to a
stream with a 10 second delay, it would be impossible to properly adjust the processing if
that much time passed before you actually heard what you were seeing on the meters! By
advancing the Delay control to 10,000ms, what your eyes see on the meters will coincide
with what your ears are hearing. Keep in mind, however, that any changes you make to the
processing will still take 10 seconds to be audible.
Processing Meters Menu
The Processing Meters menu allows you to display the levels and activity of Omnia.9’s various gain
stages and processing sections, including Input Level, Input AGC, Wideband AGC1, Wideband AGC2,
Multiband Noise Reduction, Multiband Stereo Enhancement, Multiband AGC, Multiband Limiting,
Output Level, and MPX Level.
The Delay control works the same here as it does previous and subsequent display sections.
Input Meters Menu
The Input Meters menu allows you to monitor the audio levels entering Omnia.9 with ITU BS.1770
bar graph meters.
Loudness Meters Menu
The Loudness Meters menu provides separate loudness meters for MPX Output, L/R Ouput, and if
enabled, the output levels of external gear feeding Omnia.9’s MPX1 and MPX 2 inputs.