49
Performing and Evaluating Measurements
The
Graphic
parameter applies only to the printed output. Depending on whether the
Graphic
parameter is set to
On
or
Off
, only the numerical results or both the numerical results and the size
distribution are output. The numerical output has the following format:
CASY TT Date: 15.04.09 Serial Number: TT-2AX-9999
Time: 10:15 Setup : Tumor-03
Comment : ______________________________________________________________________
User/Siganture : ______________________________________________________________________
Capillary : 150 µm Conc.Range : OK Volume/ml : 1.431e+07 fl
X-Axis Scale : 40 µm Counts : 2911
Eval Cur. left : 12.80 µm Counts> 50µm/ml : 1.500e+02
Eval Cur. right: 40.00 µm Aggr. Correct : 4.249e+03 fl Mean Diameter : 21.10 µm
Norm Cur. left : 7.60 µm Aggr. Fact. : 1.157 Mean Volume : 4.917e+03 fl
Norm Cur. right: 40.00 µm Viable Cells/ml : 1.684e+05 Peak Diameter : 20.10 µm
Sample Volume :3 x 400 µl Total Cells/ml : 2.028e+05 Peak Volume : 4.250e+03 fl
Dilution : 5.000e+01 % Viability : 83.04 % Interface : Parallel
%Calculation : Viability Cell Debris/ml : 7.843e+04 Print Mode : Manual
The
Comment
and
User/Signature
rows are intended for handwritten comments on the measuring
results and a signature where appropriate.
The size distribution is inserted between the User/Signature and the Measuring Results rows if the
Graphic
parameter is set to
On
.
This example shows the format of the numerical printout for settings
%Calculation = %Via and
Aggr.Correct = Manual
. Details on possible settings can be found in Chapter 5.4. Depending on
your settings, some of the parameters visible in this example may not appear and/or alternative
parameters are shown.
When you have selected
Par
or
P + S
as an interface, a printer must be connected to the parallel in-
terface. When you have not switched on your printer or if it is not correctly connected, the following
error message appears when you try to output data.
ERROR SCREEN
TT-2AB-9999 15.04.2009 10:15
Error-Code: CM-1
Printer does not respond!
Be sure that your Printer is
switched on and connected.
PRESS ENTER TO CONFIRM OR PRINT TO GET A HARDCOPY
Press
ENTER
to confirm the error message, switch the printer on, or check that it is correctly
connected. Having resolved the cause of the error, you can resume outputting the data by pressing
.
Outputting the Results
