Oliver LEGACY ELITE 2022, Manual

Page: 353 / 410

353
XANTREX FREEDOM XC PRO INVERTER
AC/DC and GFCI Panel
10 Freedom XC PRO Owner's Guide
AC/DC and GFCI Panel
4
1
5
15 16
17
16
6
14
7 8 9
2
10
9
11
12
13
3
3
17
Figure 2 AC/DC and GFCI Panel
WARNING
ELECTRICAL SHOCK HAZARD
Use a torque screwdriver to tighten the captive nut panel screw to
5 in-lb (0.56 N-m) torque of force to ensure a proper ground
connection and a required tool access to the wiring compartment.
Failure to follow these instructions can result in death, serious
injury, or equipment damage .
Item Description
1
Captive nut panel screw holds the AC compartment
cover in place. See WARNING above.
2 Ventilation grille (openings) must not be obstructed.
3
Grounding lug provides a ground path for the Freedom
XC PRO chassis to the DC system ground. See
WARNING.
4
DC terminal
opening for routing (–) negative DC cable.
5 DC terminal opening for routing (+) positive DC cable.
6 LED indicator for reverse DC polarity.
7 AC output terminal opening for routing AC output wiring.
8 AC input terminal opening for routing AC input wiring.
Table 2 AC/DC and GFCI Panel Features
AC/DC and GFCI Panel
975-0799-01-01 11
Item Description
9
USB port can only be used for updating the unit’s
firmware. It is not used for powering USB devices.
10 LED indicator for communication and control activation.
11
BTS port can be used for plugging in a battery
temperature sensor [BTS (PN: 808-0232-01), sold
separately].
12
Remote port allows you to connect the Freedom X
Remote Panel with cable (PN: 808-0817-01) (sold
separately) which is a remote control device accessory.
13
20-pin CC (communications and control) port connects
with the optional 20-pin Communications Harness (PN:
808-0820) (sold separately).
14
GFCI cover is removed when installing a qualified GFCI
device.
15
20 A supplementary protector with reset button
provides overload protection for the Freedom XC
PROGFCI Kit (PN: 808-9817) (sold separately) option.
Press to recover from an overload condition. In a hard
wired installation, the supplementary protector does not
protect output wiring.
Item Description
16
Ventilation grille (openings) must not be obstructed for
the proper operation of the cooling fan and
inverter/charger. When the inverter/charger is mounted,
the ventilation grille must not point up or down.
Cooling fans turn on when the internal temperature
reaches a set point temperature.
17
Mounting flanges on both sides allow you to mount the
inverter/charger permanently on deck or on a wall.
WARNING
ELECTRICAL SHOCK HAZARD
n
Use a torque screwdriver to tighten the bolt on the DC
ground lug to a torque of 23 in-lb (2.6 N-m) of force.
n
Apply an anti-corrosion compound to the copper wire prior
to connecting to the DC ground lug.
Failure to follow these instructions can result in death, serious
injury, or equipment damage .