Oliver LEGACY ELITE 2022, Manual

Page: 111 / 410

111
CRADLEPOINT WIRELESS WAN
©2017 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com 74
User Manual / IBR900/IBR950 1/5/17
• TCP
• UDP
• GRE
• ESP
• SCTP
Source IP Address , Source Netmask , Destination IP Address , and Destination Netmask : Specify an IP address
or range of IP addresses by combining an IP address with a netmask for either “source” or “destination” (or
both). Source vs. destination is defined by traffic flow. Leave these blank to include all IP addresses (such as if
your rule is defined by a particular port instead).
EXAMPLE : If you want to associate this rule with your guest LAN, you could input the IP address and netmask
for the guest LAN here (leaving the last slot “0” to allow for any user attached to the guest network):
•
Source IP Address: 192.168.10.0
• Source Netmask: 255.255.255.0
Failover : (Default: Selected.) When this is selected and traffic from the chosen WAN device for this rule is
interrupted, the router will fail over to another available WAN device. Deselect this option to restrict this
traffic to only the selected WAN interface.
When Condition Value
Port Is USB Port 1
Type Is not WiMax
• When :
• Port – Select by the physical port on the router that you are plugging the modem into (e.g., “USB Port
2”).
• Manufacturer – Select by the modem manufacturer (e.g., “Cradlepoint Inc.”).
• Model – Set your rule according to the specific model of modem.
• Type – Select by type of Internet source (Ethernet, LTE, Modem, Wireless as WAN, WiMAX).
• Serial Number – Select a 3G or LTE modem by the serial number.
• MAC Address – Select from a dropdown list of attached devices.
• Unique ID – Select by ID. This is generated by the router and displayed when the device is connected
to the router.
• Condition : Select “is,” “is not,” “starts with,” “contains,” or “ends with” to create your condition’s
statement.
• Value : If the correct values are available, select from the dropdown list. You may need to manually input
the value.
Load Balance Algorithm : Select the Load Balance Algorithm for this WAN Affinity rule from the following
dropdown options:
•
Round-Robin : Evenly distribute each session to the available WAN connections.
• Rate : Distribute load based on the current upload and download rates. A WAN device’s upload and
download bandwidth values can be set in CONNECTION MANAGER .
• Spillover : This was the default algorithm in older (version 3) firmware. Load is always given to devices with
the most available bandwidth. The estimated bandwidth rate is based on a combination of the upload and
download configuration values and the observed capabilities of the device.
• Data Usage : This mode works in concert with the Data Usage feature. The router will make a best effort to
keep data usage between interfaces at a similar percentage of the assigned data cap in the data usage rule
for each interface, rather than distributing sessions based solely on bandwidth. For proper functioning you
need to create data usage rules for each WAN device you will be load balancing. Make certain to select the
“Use with Load Balancing” checkbox in the data usage rule editor.