Oliver LEGACY ELITE 2022, Manual

Page: 137 / 410

137
CRADLEPOINT WIRELESS WAN
©2017 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com 100
User Manual / IBR900/IBR950 1/5/17
GPIOs allow you to monitor inputs and produce outputs with
simple conditions.
Special note for ‘1 on power cable’ and ‘5 on expander’ GPIOs: If
either one of these pins is set to Ignition Sensing, you must leave
the other pin unused and disconnected.
Wiring reference:
GPIO 1 - pins 7, 8 on serial cable
GPIO 2 - pins 2, 3 on serial cable
GPIO 3 - pins 4, 6 on serial cable
GPIO Name: Name of this GPIO. For example ‘East door’ or
‘Vehicle engine’. This will be used to form an alert string e.g.,
‘East door is closed.’ or ‘Vehicle engine is running.’
Low State Name: Name of the low state of this gpio. For
example ‘closed’ or ‘not running’. This will be used to form
an alert string e.g., ‘East door is closed.’ or ‘Vehicle engine is
running.’
High State Name: Name of the high state of this gpio. For
example ‘closed’ or ‘not running’. This will be used to form
an alert string e.g., ‘East door is closed.’ or ‘Vehicle engine is
running.’
Alert Trigger State: Configure which active state should trigger an alert.
Input Delay Duration: Input delay duration setting aims to minimize the number of false positives by waiting a
set number of seconds and confirming that the GPIO value is still the same, before triggering configured action.
It’s important to note that there is an additional 200ms delay, even when this setting is at 0 seconds.
Action: Used to configure the Input and Output General Purpose I/O pins.
• Default/Low: In this mode the output pin is not used and is at 0V (ground potential).
SERIAL REDIRECTOR
A single USB Serial device can be used to establish a serial link to a host port on the router. The USB Serial
device can also be accessed by running “serial” from an SSH session.
Telnet to Serial Configuration
• Enabled : Enabling Telnet to Serial will start a Telnet server that
passes its connection to the serial adapter. Enabling this service
is not necessary when accessing serial through SSH.
• LAN : Enable serial redirector for LAN connections.
• Authenticated LAN : Enable serial redirector for Authenticated
LAN connections. You must be logged into the router to use the
redirector.
• WAN : Enable serial redirector for WAN connections.
• Server Port : Enter a port number for the redirector to use. (Default: 7218)
GPIO CONFIGURATION