Oliver LEGACY ELITE 2022, Manual

Page: 338 / 410

338
4
1.
3.
4.
5.
6.
7.
9.
2.
8.
10.
DIsH receiver setup
If using two DIsH receivers with the Carryout G2
+
antenna, both receivers must be configured off of the primary
port by following the steps below.
Disconnect coax cable from the satellite In port on the back
of the receiver.
Press Menu on your remote. select option 6, System Setup .
select option 1, Installation .
select option 1, Point Dish .
select Check Switch .
select Test . It will go through a number of steps, then return
to the screen shown here with previous information cleared.
If at any point it asks you to save, select
Save or Yes .
reconnect coax cable to “sat In” port on back of receiver.
Power on the antenna. Allow the antenna 3–4 minutes to
acquire satellites.
Check that there are no check marks by superDIsH or
Alternate. If setting up a DIsH 311, 301, or 500 series
receiver, in some cases you may need to check the boxes
next to superDish and Alternate before running the Check
switch test.
next, select
Test again to install the sw64 switch. this sw64
switch is a DIsH receiver setting, not a physical part.
when you see the sw64 as the installed switch, the antenna is
ready for use.
Carryout G2
+
Antenna
satellite In
port
Back of 211z receiver shown
WINEGARD CARRYOUT G2+ SATELLITE ANTENNA