Page 19
DH1 BASE UNIT / DH2 WIRELESS GATEWAY
USER GUIDE
1.
Mount Gateway onto DIN Rail Inside of an Enclosure
a.
Remove top cover on Gateway held by 2 screws, then loosen the
2 DIN Rail Clamp screws
b.
Loop the connector ends through the opening in the bottom of
the enclosure, including compression fitting, before mounting
devices in the enclosure
c.
Mount Gateway onto DIN Rail (DIN1: 32 mm/1.3” or DIN3: 35
mm/1.4” DIN) and Adjust DIN Rail Clamp
d.
Tighten DIN Rail Clamp Screw and Reattach Cover
2.
Drilling a Hole on the Bottom of Enclosure for Routing Antenna
Cable May Be Required
(5/16” or larger diameter hole
recommended, user must supply own O-ring/sealing)
3.
Connect Antenna
a.
Firmly hold and connect MMCX end of the antenna cable to
Gateway Radio (listen for a “click” sound for confirmation)
b.
Connect Lightning Arrestor (optional – highly recommended)
c.
Drilling a hole may be required for routing antenna cable – use
5/16” or larger diameter, user must supply own O-ring/sealing
d.
Use proper fittings to seal hole for antenna cable
e.
Where bulkhead (black phantom) antennas are used, the inner
surface, outer surface, and inner wall of the hole drilled, should
be isolated from the antenna.
Use the rubber washers supplied by
manufacturer to isolate the antennas from the enclosures
(use
thickest washer supplied by manufacturer to isolate the antennas
from the enclosures (use thickest washer on exterior side of
enclosure).
f.
Install antenna and connect all cables
g.
Must install omni or bulkhead antenna in upright position
Do not mount sideways! (Ne pas monter sur le côté !)
Controlled Copy
