Page: 73
Service Guide ML320/ML321
Chapter 3 Maintenance & Disassembly
3.2.25 Pressure Roller Assembly
Perform these procedures first:
- 3.2.01 (
)
- 3.2.02 (
)
- 3.2.04 (
)
- 3.2.22 (
)
- 3.2.23 (
)
- Remove the paper chute (1).
- Turn the release link (2) as shown in View A so the spine (3) is aligned with the slot
(4) in the guide hole.
- Slide the release link off the pressure roller assembly (5).
- Remove the pressure roller assembly by sliding it through the guide hole (6).
NOTES:
Installation
Attach the paper end lever (7) to the shaft of the sensor lever (8). Refer to View B for
the correct position. If the paper end lever is incorrectly positioned, paper jams / no
paper-end indications will occur.