G3D T-1000 Quick Start Manual Download

Page: 1 / 4

ACME Thread

VAT

VAT Stopper

Head Stopper

Build Plate

Calibration Lever

Wiﬁ Reset

Ethernet Port

USB Port

Electronic Panel

Power Button

Main Switch

Fuse Holder

Power Cable

Handle

T-1000 QUICK START GUIDE

This quick start guide explains basic instructions on how to unbox and set up the T-1000 3D printer. For more

information, please refer to the T-1000 manual, available for download at g3dsys.com.

ACCESSORIES CHECKLIST

COMPONENTS

Resin

VAT

Scraper

Build Plate

Clippers

GUIDE

Quick Guide

Summary of Contents for T-1000

Page 1: ...ton 13 Main Switch 14 Fuse Holder 15 Power Cable 12 Handle 13 14 15 12 T 1000 QUICK START GUIDE This quick start guide explains basic instructions on how to unbox and set up the T 1000 3D printer For...

Page 2: ...ccessory box handles Open the accessory box to check if the accessories are inside REMOVE THE ACCESSORY BOX TILT THE T 1000 BOX Slightly tilt the T 1000 box Make sure to hold or lean the T 1000 box ag...

Page 3: ...one person 2 person lift can be optional Use the side handles of the printer to separate the printer from the bottom foam support Place the printer on a flat ground 10 REMOVE THE HEAD STOPPER Rotate t...

Page 4: ...n the 4 four VAT stoppers only enough to snug them against the VAT Do not overtighten the VAT stoppers because it can damage the VAT 16 PLUG THE POWER CABLE Insert the power cable into a power outlet...