OKIDATA DOC-IT3000, Service Manual

Page: 334 / 428

Page: 229
Service Guide DOC-IT3000/4000
Chapter 4 Failure & Repair Analysis
4.3.06 POWERON.EXE - Operational Error Messages
MESSAGE
INDICATION FAILURE
DESCRIPTION CAUSE RECOMMENDED
ACTION
Could not open the
DDP.CFG file The program could not
find or open the
DDP.CFG file The Doc-It
environment path
is incorrect Close a few of the
DOS files that are
already open
Could not find the
errors file name The program could not
find the specified error
file Incorrect number
of characters in file
name Check to make sure
that you are using a
legal DOS file
Invalid switch
value An invalid switch value
was used in the
POWERON .EXE
program Incorrect key was
entered Enter the correct
character
Invalid number of
wait states An invalid numerical
value was used An invalid number
was entered with
the \w command Use only (01) for
number of wait states
Doc-It controller
board not found The presence of the
Doc-It controller board
was not detected by
the program The Doc-It
controller board is
not connected
correctly or the
configuration is
incorrect Make sure the Doc-It
controller board is
installed correctly and
check that there is not
a conflict with other
boards and verify that
the configuration is
correct
Doc-It poweron
test: the 16K I/O
address is in use The page frame
specified in DDP.CFG
file is used by some
other hardware Conflict between
devices Run the CONFIG .EXE
program and choose
another address base
Memory Bank : n
1MB SIMMS
installed in this
bank failed 1 or 2 MB memory
module in bank n but
the memory bank
failed Defective SIMM
or SIMMs Replace the SIMM or
replace the Doc-It
controller board