Oki OKIFAX 5750, User Manual

Page: 43 / 154

English
Chapter 3 - Installation 29
without activating the answering machine. If the incoming call is a voice
communication, the machine will ring as it does when in TEL. If the call
goes unanswered, the machine transfers the call to the answering machine,
allowing the calling party to leave a message. If the caller decides to send
a fax, the machine automatically switches modes to receive the fax.
Note
that this receive mode is not available if the optional ISDN G4 board is
installed.
Note: TAD is normally not activated. To have it activated, please
contact your supplier.
Memory Reception Mode (MEM) : Data from incoming fax communi-
cations is stored in memory even if there is paper loaded in the machine.
The PRINT OPERATION function is used to print out the data stored in
memory when the machine is in MEM.
Note: If a memory password has been set (see Memory Password in
Chapter 6), this mode cannot be changed to another mode
without first entering the password. After entering the password
and switching between modes, there is no need to enter the pass-
word again when printing data from memory without returning
to the standby mode. However, faxes received and marked for
confidential or polling will be stored in memory and not
forwarded.
Forwarding Mode (FWD) : When set to this mode the machine will
receive all fax communications into memory, and then automatically send
the messages to the telephone number programmed into the Call
Forwarding function (
see Call Forwarding in Chapter 5 ).
PC Mode (PC, optional) : This mode is only available when the machine
is connected to a personal computer via the optional multifunction periph-
eral (MFP) software. When activated, the machine does not respond to the
signal, but forwards it directly to the computer. Fax reception by the
computer is enabled upon receiving the call signal.
Note: The optional MFP driver must be installed in the computer to use
this function.
Setting answering mode
1. Press MENU/EXIT to enter the menu.
2. Enter speed access No. 10 (Auto Answer) and wait for the Auto
Answer prompt in the display.
3. Press
"
or
!
to select the desired mode, press ENTER.
5750GB.book Page 29 Tuesday, June 6, 2000 8:08 PM