Oki OKIFAX 5750, User Manual, Page: 83 / 154

English
Chapter 6 - Customising 69
Power save mode
When this function is set to ON, the machine will automatically switch to
a low-energy mode after being idle for 10 minutes. Available settings are
ON and OFF. Speed access No. 26.
Pulse dial rate
If the machine is set for pulse dialling, this function controls the rate of the
dialling pulses (which vary by country). Available settings are 10, 16 and
20pulses per second. Speed access No. 46.
Pulse make ratio
If the machine is set for pulse dialling, this function controls the make rate
of the dialling pulses. Available settings are 33, 39 and 40%. Speed access
No. 47.
Pulse dial type
If the machine is set for pulse dialling, this function controls the type of
pulse dialling it uses (types of pulse dialling vary by country). Available
settings are N, 10-N and N+1. Speed access No. 48.
T/F timer
When set to T/F (TEL/FAX), the machine will automatically distinguish
between incoming voice and fax communications. The T/F timer controls
how long the machine waits for the call to be answered before switching
to FAX mode. Available settings are 20 and 35sec. Speed access No. 62.
CNG Count
When set either in the T/F or TAD modes, the machine detects the type of
signal (calling tone, CNG) sent from the remote location and initiates fax
reception if required. This function sets the CNG detection number. The
available setting is 1-5 times (numeric keypad input). Speed access No.
65.
Ring response
This function controls how long the machine waits before answering an
incoming call. The available settings are 1 ring, 5, 10, 15 and 20sec. Speed
access No. 66.
5750GB.book Page 69 Tuesday, June 6, 2000 8:08 PM