4.2.17 Cover Assy Rear
(1) Remove the Cover-Side-R and Cover–Side-L. (Refer to 4.2.4 / 4.2.5)
(2) Remove the CU-Board. (Refer to 4.2.6)
(3) Remove the Sheet-Insulation-CU. (Refer to 4.2.9)
(4) Remove the Spacer
①
.
(5) Slide Cover Assy Rear
②
and pull it out of the hole on the right of the
printer.
(Remove Cover Assy Rear
②
carefully to avoid Cable-Sensor-FU
③
from
being caught.)
①
②
③
④
④
⑤
⑥
⑦
⑧
⑧
⑨
⑨
⑩
⑭
⑪
⑫
⑬
⑮
⑯
(6) Remove the two screws (Black)
④
and separate Cover-Rear
⑤
and
Guide-Eject-Upper-Assy
⑥
.
(7) Remove the Gear-Idle
⑦
.
(8) Remove the Gear-Exit
⑧
(2 places), remove the Bearing-Eject_R
⑨
(2
places). Remove the Bearing-Feeder
⑩
.
(9) Remove the Shaft-Assy-Eject
⑪
(2 places).
(10) Remove the Separator-FU
⑫
. Remove the Spring-Separator_FU
⑬
and
Bearing-Feeder
⑭ .
(11) Remove the Stacker-Sensor
⑮
.
Remove the Cable-Sensor-FU
⑯
.
(12) Assembling is performed by the inverse procedure with removing.
(Note on removing / assembling)
1. Beware of not to touch the DC motor inattentively (Do not rotate motor).
4-19
4. REPLACEMENT OF PARTS
