3-20
3.1.6.7 Number of print copies counter display
This self-diagnostic menu is used to display status of the number of copies of a printer.
1. Enter the self-diagnostic mode (level 1), press the [MENU
] or
[MENU
]
key
repeatedly ,and press the [OK] key when the "PRINTER STATUS" is displayed
in the upper row of the display area. (Pressing the [MENU
]
key increments the
test item and pressing the [MENU
]
key decrements the test item.)
2. When the [MENU
]
, [MENU
]
key is pressed, statuses of the number of print
copies are displayed in order.(Pressing the [ONLINE] or [CANCEL] key is
invalid.)
3. Pressing the [ ] key terminates the test. (Returns to the status of step 1.)
Display area,
upper row
Display area,
lower row
Format
Unit
Details
K-TOTAL
DRUM CNT
********IMAGES
DEC
Images
It shows the cumulative number of
rotations.
TOTAL SHEET
CNT
********COUNTS
DEC
Prints
Total number of print copies are
displayed.
3.1.6.8 Switching between the Factory mode and the Shipping mode
This self-diagnostic menu item is used to switch between the Factory mode and the
Shipping mode.
1. Enter the self-diagnostic mode (level 1) and keep pressing the [MENU ] or
[MENU ] key until the following message is displayed.
FACTORY MODE SET
2. When the [OK] key is pressed, the following message is displayed. Keep
pressing the [MENU ] or [MENU ]key until the target item (refer to the following
table) is displayed.
FACTORY MODE
SHIPPING MODE *
3. While the desired item to set is being displayed, press the [OK] key that enables
selection of the setting values.
4. While the desired setting value is being displayed, press the [OK] key for long
period (3 seconds) that registers the displayed value in EEPROM. (Returns to
the status of step 2.)
5. Repeat steps 2 to 4 as required.
6. Pressing the [ ] key terminates the test. (Returns to the status of step 1.)
Display
Setting value
Function
FACTORY
MODE
FACTORY MODE
Sets the Factory working mode (fuse cut invalid mode).
SHIPPING MODE
Releases the Factory working mode to make the fuse cut
function valid.
FUSE INTACT
Note:
******* indicates
INTACT or BLOWN.
ID UNIT ******
Checks the fuse status of the K-ID unit.
3. ADJUSTMENT
