OHAUS T51P, Instruction Manual

Page: 50 / 64

EN- 5000 Series Indicators
5. SERIAL COMMUNICATION
The T51P and T51XW Indcators nclude an RS232 seral communcaton nterface.
The setup of RS232 operatng parameters are more fully explaned n Secton 3.10. The physcal hardware connecton s
explaned n Secton 2.6.
The nterface enables dsplay and GMP data to be sent to a computer or prnter. A computer can be used to control some
functons of the ndcator usng the commands lsted n Table 5-1.
5.1 Interface Commands
Communcate to the ndcator usng the command characters lsted n Table 5-1.
TABLE 5-1. SERIAL INTERFACE COMMAND TABLE.
Command
Character
1)
Function
IP Immedate Prnt of dsplayed weght (stable or unstable).
P
2)
Prnt dsplayed weght (stable or unstable).
CP Contnuous Prnt.
SP Prnt on Stablty.
xP Interval Prnt x = Prnt Interval (1-3600 sec)
Z
2)
Same as pressng Zero button
T
2)
Same as pressng Tare button
xT Enter a preset tare, where x = the tare value n grams.
PU Prnt current unt: g, kg, lb, oz, lb:oz, t, C (custom)
xU Set scale to unt x: 1=g, 2=kg, 3=lb, 4=oz, 5=lb:oz, 6=t, 7=C
PV Verson: prnt name, software revson and LFT ON (f LFT s set ON).
H x “text” Enter Header lne , where x = lne number 1 to 5, “text” = header text up to 24 alphanumerc
characters
Esc R Global reset to reset all menu settngs to the orgnal factory defaults
xS
4)
Prnt stable only. Where x=0 Off, x=1 On.
AS
4)
Automatcally send data when stable after moton.
xxxxS
4)
Send at nterval. Where xxxx=1 to 3600 seconds.
CS
4)
Send as fast as possble (contnuous prnt).
M
4)
Increment to next enabled unt.
?
4)
Prnt current unt: kg, g, lb, oz.
NOTES :
1) Commands sent to the Indcator must be termnated wth a carrage return (CR) or carrage return-lne feed (CRLF).
2) Alternate command characters may be defned by the user (see Alternate Commands n Secton 3.10).
3) Data output by the Indcator s always termnated wth a carrage return-lne feed (CRLF).
4) These commands are only avalable when Prnt>Output s set to C11 (see Secton 3.9.6).