Oce VarioPrint 2090, User Manual

Page: 107 / 187

The copy function 107
Correct the settings for a copy job
Introduction
Task for operators
You can define or change the settings of a copy job until you press the Start key
or the Set-build key . When you create a copy job, you open the job
editor. There you select the required job settings. Use the Correction key
to correct the settings.
How to correct the quantity setting for a copy job
1
Press the Correction key one time to reset the quantity setting (number of
prints).
2
Use the numeric keys to enter a new value.
3
Press the Start key to send the job to the job queue.
How to correct the settings in the copy job sections
1
Press the Correction key two times to reset the values in the 4 sections of
the job editor. This action changes all the copy job settings back to the default
value.
2
Use the function keys above the operator panel to access the 4 copy job
sections.
3
Use the function keys below the operator panel to define the settings for each
section.
4
Press the Start key to send the job to the job queue.