Oce CS7075, User Manual

Page: 86 / 182

3-30 Loading Rigid Media
9. If necessary, prepare the printer to print on thicker or thinner
media.
To shield the UV light, the printer requires different setups
when printing on media thicker than 0.25 inches (6.35 mm)
than when printing on media less than this thickness. If the
height of sheet-fed media exceeds 0.25 inches (6.35 mm) —
the height of the media alignment bar, you must prepare the
printer as follows before printing:
◆
Raise the head height (see “Set the Printhead Height” on
page 5-11)
◆
Raise the right-side louver assembly
◆
Install the left-side light-blocking mat (engage the two
pins on the mat into two corresponding vacuum holes in
the platen near the edge of the media)
Fig. 3-14. Preparing the printer to print on 0.25-0.50 inch media
Light-blocking mat
Raise/lower levers
Service station cover shown opened