Oce CS7075, User Manual

Page: 172 / 182

B-12 Diagnostics
A-MS-6 Thickness Sensor Discon-
nected The media thickness sensor is dis-
connected or reading an invalid
value. Ensure that the media thickness
sensor is connected and calibrated.
If the problem persists, contact
your Océ Authorized Service Pro-
vider or Océ Technical Support.
W-MS-1 Media Low Between 10 feet (3 meters) and 1
foot (30 cm) or less of media
remains. Load media.
W-MS-4 Media Advance Switch
Detected Media Advance Switch on back of
printer was depressed. Use the Load or Unload button to
finish operation.
W-MS-6 Media Too Wide Media is too wide for printing. Use narrower media. See manual
for specifications.
(PR) Pinch Rollers
A-PR-1 Pinch Rollers Up The pinch rollers are up, in the
media release position. Lower the pinch rollers and lock
them into the appropriate slot.
Refer to the current media settings
for determining the correct slot. If
media is out, run the media load
procedure.
(PC) Printer Calibration
W-PC-2 Media Replaced - Recali-
brate Media advance accuracy may need
to be recalibrated. Calibrate media feed if media type
was changed.
W-PC-3 Head Height Changed -
Recalibrate Change in head height has invali-
dated calibration. Run Autoset.
W-PC-4 Jets Not Replaced Not all missing jets could replaced. Prime/clean cartriges, or increase
the print mode quality.
W-PC-6 Uncalibrated Pass Mode Print mode selected has media
advance rate different from the cal-
ibrated advance rate, which may
cause banding. Calibrate media feed.
W-PC-7 Platen Width Not Known Measurement was reset or not per-
formed. Restart printer to measure platen
width.
W-PC-8 Thickness Sensor Uncali-
brated The media thickness sensor has not
been calibrated. Calibrate the sensor using the
menu item in the service menu.
Table B-1. Action and Warning Messages
Description Cause What to do