Oce CS7075, User Manual

Page: 140 / 182

5-12 Set the Printhead Height
the printheads, not to the bottom of the UV lamp assem-
blies (see Fig. 5-7 below).
8. Use the supplied hex wrench to turn one of the head height
adjustment screws counterclockwise until the end of the
gauge will
not fit under the carriage.
The head height adjustment screws can be accessed from the
top of the carriage. The access holes are labeled with a white
circular label.
Caution
Do not allow any part of the gauge to touch the
printheads, and do not leave the gauge on the
platen after setting the head height. If the gauge is
allowed to touch or strike the printheads, the print-
heads could be damaged permanently and require
replacement. The printer has a protective frame
around the printheads to reduce the chance of any-
thing striking them.
9. Turn the head height adjustment screw clockwise, just until
the end of the gauge slides under the carriage.
10. Remove the gauge and repeat steps 7 through 9 at the other
side of the carriage.
11. Verify the heights at both sides of the carriage and adjust if
necessary.
12. Press

to return the carriage to the wiping station.
Fig. 5-7. Head height measurement points A and B
A B
Lamp Lamp