Oce CS231, Operation Manual

Page: 514 / 594

13 Utility mode
13-22 CS240/CS231
13.4 Specifying administrator settings
This section describes the function and main registration parameters that can be specified after pressing the
[Utility/Counter] key, then touching [Administrator Settings].
System settings
Power Save Settings
Output Settings
* CS231: If finisher FS-519 is installed, “Tray 3” is selected as the default setting.
2
Reminder
The "Output Tray Setting" parameter is available only if the optional finisher is installed.
CS231: [Bin Assignment] only appears if the optional mailbin kit is installed.
The “Bin Assignment” parameter is set to “Tray 2” only if the optional output tray is installed.
Date&Time Settings
Daylight Saving Time
Parameter Description Default Setting
Low Power Mode Set-
tings Specify the desired length of time (between 10 and 240 min-
utes) until the machine enters Power Save mode. 15 minutes
Sleep Mode Setting Specify the desired length of time (between 15 and 240 min-
utes) until the machine enters Sleep mode. 30 minutes
Power Save Key Select which low power mode is entered when the [Power
Save] key is pressed.
•
Low Power:
The touch panel goes off and the machine enters a mode
where it conserves energy.
• Sleep:
Although the machine conserves more energy in Sleep
mode than in Power Save mode, the machine must warm
up when Sleep mode is canceled, therefore taking more
preparation time than Power Save mode.
Low Power
Enter Power Save
Mode Specify settings for faxing. For details, refer to the User man-
ual – Fax Operations (Option) and the User manual – Network
Fax Operations (Option). Normal
Parameter Description Default Setting
Print/Fax Output Set-
tings Specify settings for faxing and printing. For details, refer to the User manual – Fax Operations
(Option) and the User manual – Print Operations.
Output Tray Settings Select the finishing tray for each type of job (copies, printouts,
faxes and reports). Copy: Tray 1
Printer: Tray 1
Print Reports: Tray 2*
Fax: Tray 2*
Bin Assignment
(CS231) Select whether or not Tray 1 is specified as mailbin 5 and the op-
tional output tray is specified as mailbin 6. Not Set
Shift Output Each Job Select whether or not printed copies are fed out shifted when
"Offset" is selected while a finisher is installed.
•
Yes: Pages are fed out shifted.
• No: Pages are fed out without being shifted.
Yes
Description Default Setting
Specify the current date and time. In addition, the time zone can be set between -12:00
and 13:00 (in 30-minute increments). Time Zone: +00:00
Description Default Setting
Select whether or not the machine’s internal clock observes daylight saving time. If
"Yes" is selected, a setting appears so that the length of time for adjusting the current
time can be set. The length of time applied for daylight saving time can be set between
1 and 150 minutes in 1-minute increments. No