Oce CS191 Phase 3, User Manual

Page: 10 / 712

Contents-8 CS191 (Phase3)
6 Troubleshooting
6.1 When the message “Malfunction detected.” appears
(call technical representative) .......................................................... 6-3
To call the technical representative ................................................ 6-5
6.2 When the message “Misfeed detected.” appears .......................... 6-6
Location of paper misfeed .............................................................. 6-6
Paper misfeed indications .............................................................. 6-8
To clear a paper misfeed in the bypass tray................................. 6-10
To clear a paper misfeed in the ADU............................................ 6-12
To clear a paper misfeed in the tray 1 .......................................... 6-13
To clear a paper misfeed in the tray 2 .......................................... 6-15
To clear a paper misfeed in a paper tray (tray 3 or 4)................... 6-16
To clear a paper misfeed in the LCT............................................. 6-17
To clear a paper misfeed in the right-side door............................ 6-18
To clear a paper misfeed in the fusing unit................................... 6-21
To clear a banner paper misfeed .................................................. 6-25
To clear a paper misfeed in the ADF (feed section)...................... 6-30
To clear a paper misfeed in the ADF (transport section) .............. 6-33
To clear a paper misfeed in the ADF (scanning section) .............. 6-36
To clear a paper misfeed in the ADF (output section) .................. 6-40
To clear a paper misfeed in the ADF (turnover section)................ 6-43
To clear a paper misfeed in the finisher........................................ 6-46
To clear a paper misfeed in the mailbin........................................ 6-49
To clear a paper misfeed in the saddle stitcher............................ 6-51
6.3 When the message “Replenish paper.” appears.......................... 6-53
To replenish paper ........................................................................ 6-53
6.4 When the message “... Not enough remaining memory.”
appears............................................................................................. 6-54
Memory becomes full while scanning........................................... 6-54
Memory becomes full while queuing a job ................................... 6-55
6.5 When “Please replace following unit(s).” appears ....................... 6-56
6.6 When the message “Need to replace XXXX.” appears ................ 6-57
6.7 Simple troubleshooting................................................................... 6-59
Main unit ....................................................................................... 6-59
ADF ............................................................................................... 6-62
Finisher ......................................................................................... 6-62
6.8 Main messages and their remedies............................................... 6-63