Open the bag by cutting a corner of the bag to let air get in, if the vacuum
bag is to be defrosted/heated in a microwave oven. Do not use the bags for
preparation of food, unless they are particularly made for defrosting/heating.
The bag can be heated by putting it in a saucepan with simmering water.
NOTE!
Never reuse bags that have been treated in the microwave oven or that
have been simmering in water
Vacuum packing with canister (accessory 7957)
1. Position the appliance on an even surface and plug to a wall outlet; the
signal lamp goes on.
2. Make sure that the vacuum container and the lid are clean and dry.
3. Put the raw materials in the vacuum container, but do not exceed the
maximum level. Put the lid on the vacuum container.
4. Change one of the sockets of the tube (female) against the male socket,
which is delivered with the vacuum sealer. Next, press one of the sockets
to the tube coupling (3) of the appliance and the other one in the hole of
the lid of the vacuum container.
6. Switch the lock of the lid to the “SEAL” position.
7. Press the SEAL button (9). The vacuum packing process
starts directly.
8. Press the lid with your hand at the beginning of the process in order to
avoid air leakage between the vacuum container and the lid.
9. The appliance switches off automatically after about 1 minute and the
SEAL button goes off.
10. Press the lid with your hand and pull the vacuum tube off the lid. Make
sure that the lock on the lid points towards “SEAL” when you pull out the
tube.
11. To test the result, try to lift the lid.
12. Switch the lock on the lid from “SEAL” to “OPEN” in order to open the lid
of the vacuum container. You can now remove the lid.
13. The vacuum container can be cleaned and washed in the dishwasher (not
the lid) after use. Read more in “Cleaning and maintenance”.
14.
NOTE!
The vacuum container and the lid must not be used in a microwave
oven.
Vacuum packing with lunch boxes (accessory 7961)
1. Position the appliance on an even surface and plug to a wall outlet; the
signal lamp goes on.
2. Make sure that the vacuum container and the lid are clean and dry.
3. Put the raw materials in the vacuum container, but be sure that there is
about 1 cm to the top. Put the lid on the vacuum container and make sure
that it is properly secured.
4. Remove the coupling from one end of the delivered tube to have two
”taps”. Press to engage one of the taps on the tube coupling (3) of the
appliance and next position the other one on the adapter. Next, press to
engage the adapter against the vacuum coupling of the lid.
85
7944_KK_UVN_0215.indd 85
2018-02-09 08:48:47
